One millimeter is approximately 0.0393701 inch. Divide millimeters by 25.4 to get inches. The relationship is based on the exact international inch, 25.4 mm. Display rounding does not change that definition.
Formula and unit check
inches = millimeters ÷ 25.4. Check that the input is a length, not an area or volume. A square-inch or cubic-inch conversion requires the factor to be squared or cubed; the linear chart below cannot be used unchanged.
MM to Inches Conversion Chart
| Millimeters (mm) | Inches (in) |
|---|---|
| 0.1 | 0.00 |
| 0.5 | 0.02 |
| 1 | 0.04 |
| 2 | 0.08 |
| 3 | 0.12 |
| 4 | 0.16 |
| 5 | 0.20 |
| 6 | 0.24 |
| 8 | 0.31 |
| 10 | 0.39 |
| 12 | 0.47 |
| 15 | 0.59 |
| 16 | 0.63 |
| 18 | 0.71 |
| 20 | 0.79 |
| 22 | 0.87 |
| 25 | 0.98 |
| 25.4 | 1.00 |
| 30 | 1.18 |
| 35 | 1.38 |
| 40 | 1.57 |
| 50 | 1.97 |
| 60 | 2.36 |
| 75 | 2.95 |
| 100 | 3.94 |
| 125 | 4.92 |
| 150 | 5.91 |
| 200 | 7.87 |
| 250 | 9.84 |
| 300 | 11.81 |
Convert a small dimension
A 6 mm dimension is 6 ÷ 25.4 = approximately 0.24 in at two decimals. To four decimals it is 0.2362 in. A nearby fractional ruler mark is ¼ in, but ¼ in is exactly 6.35 mm. Use that fraction only when the 0.35 mm difference is acceptable for the task.
Millimeters, mils and nominal sizes
A millimeter is one thousandth of a meter. A mil is one thousandth of an inch, or exactly 0.0254 mm. Despite the similar names, these units are very different. A 10 mil thickness is 0.254 mm, not 10 mm.
Converting a nominal trade size does not establish a product’s actual measured diameter, fit or tolerance. Check the specified physical dimension before treating a metric-to-inch result as an interchangeable component.
For larger metric dimensions see centimeters to inches. To work back from an inch dimension, see inches to centimeters and multiply the centimeter result by ten for millimeters.
Common questions
Is 25 mm exactly one inch?
No. One inch is 25.4 mm, so 25 mm is about 0.9843 in. Treating them as equal introduces a 0.4 mm difference.
How many millimeters are in ⅛ inch?
Exactly 3.175 mm: divide 25.4 mm by eight. Use the exact fraction when calculating, then round to suit the measurement task.
Sources and calculation method
All chart results are calculated from the stated full factors, then rounded once to two decimal places using round-half-up. Trailing zeros show a consistent display, not the precision of a measuring tool.
- NIST — Handbook 44 (2026), Appendix C: General Tables of Units of Measurement. C-4, C-6, C-9, C-15–19 and C-25; exact definitions and explicitly rounded equivalents distinguished.
Found an error? Read our corrections policy and contact the editors.
